You can add a vanishing point to the ruler to match the shape of the fisheye.ġ. It reduces surface tension of the wet paint film improves flow-out. If fisheyes appear in a basecoat, allow the color to flash then spray a mist coat over affected area. Our Custom Shop KE215-HP Fisheye Eliminator Additive prevents fisheyes and increases gloss. Add the recommended fisheye eliminator and respray the affected area. You can also enable snapping to the ruler or grid to help in your drawing. Remove wet paint film with solvent, clean and refinish. Do not use fisheye eliminator in undercoats or basecoat color. If fisheyes appear in a basecoat, allow the color to dry then spray a mist coat over affected area. Fish eyes are caused by contamination, most often in the form of silicone, water, oil and/or grease on the substrate. You can adjust the guide lines and vanishing point according to what you want to draw. To avoid paint bubbles before painting, thoroughly clean the surface with detergent and hot water, followed by a solvent cleaner. The lower right controller lets you turn the snap function on and off. The upper left controller changes the position of the controller to move the entire ruler. You can change the position and angel of the eye level (blue).Ĭhange the position of the eye level with the central controller and change the angle by moving the small controllers on the sides.Ī vanishing point snapped to above the eye level will also be moved if you move the eye level.Īs outlined in “Adjusting the fisheye distortion,” you can move the entire fisheye perspective ruler position. You cannot move the controller outside the lens circle.ĭrag the controller to change the center of the fisheye lens. If the paint has dried, sand to a smooth finish below. If fisheyes appear in a basecoat, allow the color to flash then spray a mist coat over affected area. The snap function can be switched on and off with the square controller on the lower right of the white circle. Remove wet paint film with solvent, clean and refinish. You can change the slope of the angle of the guide line by dragging the blue circles at both ends. Drag and move the middle white circle to move the guide lines.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |